( Suggest: the wind speed shall be under 4~5 level or lower than 15km/hr ) When RTL is activated, if the Quad-copter is lower than safe height 10m, it will pull to 10m and process RTL. ■ Return to “Launch point” – When the GPS is located, when RTL is activated by the pilot or failsafe, Quad-copter will fly back to the “Launch point” and land. ( Suggest: the wind speed shall be under 5 level or lower than 25km/hr ) “Attitude hold” is for flying indoor or without GPS located situation. Note: the Quadcopter may slight shift in the air by wind or any un-notable foreign force on it. ■ Attitude hold – The Quadcopter will hold the altitude & keep stabilized automatically while not getting any control input from the pilot or fail safe action. When “GPS hold” is turned on, the Quadcopter can’t takeoff if the GPS signal is too weak. ■ GPS hold - When GPS is located, this function will hold the Quadcopter where it is. A 3-position switch, at the top right corner of the remote control, controls 3 flight modes: GPS Hold (for outdoor), Altitude Hold (no GPS signal/indoor), and Return to “Launch point”.(Mode 1: right-hand throttle, Mode 2: left-hand throttle) A mode switch near the middle of the bottom of the remote control can change the stick mode between Mode 1 / Mode 2. The 2 control sticks control the 4 Axis (Roll, Pitch, Yaw, Up/Down) flight control.An 8 Channel radio control system has control range about 1000 meters, (depends on circumstances).■ A flight controller which is powered by a 32 bit MCU.■ An integrated sensor module including accelerometer, gyro, compass &īarometer sensors.■ A GPS module.■ Four sets of speed controllers, motors, and foldable self-tighten CW & CCW 5200Ah 4S LiPo Battery (may change or remove depended on final configurationīasic Function Introduction : AC-DC Adaptor (may change or remove depended on final configuration forĥ. DC-DC Charger (may change or remove depended on final configuration forĤ. Make sure your smartphone supports OTG.įor the latest version of APP manual, please visit included?.3Basic Function Introduction.3The Remote Control.7Function Description.8How to achieve the maximum distance?.9 The Quadcopter.10 The Quad-copter Specifications.10 Un-fold the Quadcopter.12 Fold the Quadcopter.13Charging the battery.13Battery Storage.14Flight.14 Install the battery pack.14Arm & disarm the motors.14 Motor arming.14 Disarm the motors.15 GPS hold.15 Altitude hold.15Return to “Launch point”.16Intelligent altitude mode.17Fail safe.17 Low battery fail safe.17DISCLAIMER & WARNING.18INSTRUCTIONS.18 CAUTIONS.19 USING BATTERY.20 LIMITATION OF LIABILITY.20 WARNING.22 NOTE.22Relative information download.24 ![]() For further detail, please download the APP manual through the official website.Ģ. However, this information is usually affected by WiFi. Follow mode will acquire the position information of smartphone. The most known problem occurred is in the Follow mode based on our experience. Multilingual support: English, Traditional Chinese, and Japaneseġ. No-takeoff exceptions: weak GPS signal, low voltage, system error, etc.ġ3. Follow modes: Leash, Left, Right, Lead, Above and Orbitġ2. ![]() Compass calibration (planned, not available yet)ġ1. Set "Geo Fence 500M" to prevent over-range flyawayġ0. Monitor the flight status: location, cruise speed, GPS status, voltage, altitude, etc.Ĩ. Fly to the indicated destination on mapħ. Auto take off and landing (Takeoff/Land)ĥ. Left/Right turns (available only when Smartphone Solo Control Mode is ON)ģ. Smartphone Solo Control Mode ON/OFF (please turn off the transmitter when activate this mode)Ģ. Once the Flexify reach the destination, pilot can make left/right turn by press the turn icons.ġ. There will be icons (Left and Right turns) on the screen for turning direction. Under this mode, pilot can start the motors by pressing "Arm/Disarm" button. ![]() Go to "Settings" and check "Smartphone Solo Control Mode (ON/OFF)" to enable the full functional mode. The APP can co-work with, or replace the radio control completely through the APP settings. ![]() Through intuitive design, it is easy to manipulate Flexify without much practice from the beginning. Full function Flexify control APPUser can "TURN OFF" their own radio.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |